Table of Contents
Advertisement
Steps
1. Ensure that the release lever on the processor socket is fully extended in the open position.
NOTE:
The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the
processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or
more corners of the processor are higher than the others, the processor is not seated properly.
2. Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION:
Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor cover.
Next steps
1. Install the
heat
sink.
2. Install the
system
fan.
3. Install the
system-board
4. Install the
back cover
5. Install the
cable cover
(optional).
6. Install the stand.
7. Follow the procedure in
58
Removing and installing components
shield.
After working inside your
computer.
Advertisement
Table of Contents
