KTM 125 Duke EU Setup Instructions page 5

2 SETUP
2.1 Unpacking and setting up the vehicle
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
–
Check the vehicle for transport damage.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
B00911-01
–
Position the handlebar.
The lettering on the handlebar should be situated in the middle of the handle-
bar clamp.
–
Position the handlebar clamps. Mount the four screws and tighten evenly.
Guideline
Screw, handlebar clamp
B00912-01
–
Mount and tighten the rear mirror on both sides.
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
B00913-01
–
Mount the reflector.
–
Remove the protective plastic.
–
Carefully loosen and remove the tensioning belt over the swingarm.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
700217-01
–
Take the vehicle off the pallet.
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
–
–
–
–
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. (
–
Install the battery. (
–
Refuel. (
Keep batteries out of the reach of children.
Wear suitable protective clothing and goggles.
Avoid contact with battery acid and battery gases.
Keep sparks and open flames away from the battery. Only charge in
well-ventilated rooms.
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
p. 6)
p. 7)
p. 9)
M8 21 Nm
(15.5 lbf ft)
3