Advertisement
INSTALL THE FREESTANDING BATH
INSTALL THE FREESTANDING BATH
1. Make sure the floor is as flat as possible when
choosing the position for installing the bathtub
(uneven floor or tiles could affect the overall
installation). Place the cast iron bathtub at a tilt or
place the bottom on top (at least 2-3 people required;
please be careful) and following instructions in the
following figure to adjust the supports. Adjust the
screws so that the bottom of the bathtub is 105mm
from the floor. Use the same method to install other
adjustable supports. (The height adjustment is for
facilitating follow-on installation of the wood base and
it is suitable for flat surfaces.)
105
2. After the supports are adjusted, return the cast iron
bathtub to its normal position with the bottom facing
down as illustrated in the following figure. Shake the
cast iron bathtub to verify whether the four supports
are even. If the bathtub is shakable, it means that the
floor is not sufficiently even. You can use a wrench to
adjust 1 screw with the highest deviation so that the
four supports are placed on the floor.
Install and tighten the bathtub water drain and pull
out the drainage pipe.
1315528-T01-C
1.
Bath
M8
M12
Adjustable Feet
2.
-3-
2-3
105mm
Go Down
Go Up
Tighten
Tighten
1
Advertisement
