Table of Contents
Advertisement
Figure 39. Attaching the low-profile tailstock to a PCIe adapter
15. If the new adapter is a 4-Port 10/100/1000 Base-TX PCI Express adapter, first engage the tailstock
with the tabs on the card hardware. After the tailstock is attached, secure the tailstock with its screw.
16. If the new adapter is an Ethernet or Fibre Channel adapter, you must attach the SFP transceivers
after you replace the tailstock.
To attach the SFP transceivers, complete the following steps:
a) Place the card flat on a static-protective surface.
b) Slide the transceiver (A) into the adapter hardware.
c) With the latch (B) in the open position, push the latch by rotating it up and toward the card as
shown in Figure 40 on page 56.
d) Repeat for the other transceiver.
Installing, removing, and replacing PCIe adapters in the 9040-MR9 system 55
Advertisement
Table of Contents
