Table of Contents
Advertisement
2.6
DRS Radar Sensor Connections
The figures below show connection examples with radar sensors which are compati-
ble with the TZT16F.
For details regarding connection and cables required for connection with the radar
sensor, see the radar sensor's installation manual.
Connection examples for radome sensors
DRS4DL+, DRS4D NXT
To ship mains
(12 to 24 VDC)
HUB-101
2.7
Network Connector
Like previous NavNet series equipment, the TZT16F may share Radar and Fish Find-
er images, and other information, across a Ethernet connection. Up to six TZT16F
units may be connected to the same network at one time. However, for configurations
with one or more TZT2BB included, the maximum number of networked TZT16F units
is four. TZT16F is equipped with a network connector (RJ45).
2.8
CAN bus (NMEA2000 Connector)
Every TZT16F has one CAN bus connector (micro style connector). All TZT16F must
be connected to the same CAN bus backbone.
What is CAN bus?
CAN bus is a communication protocol (NMEA2000 compliant) that shares multiple
data and signals through a single backbone cable. You can simply connect any CAN
bus devices onto the backbone cable to expand your network on-board. With CAN
bus, IDs are assigned to all the devices in the network, and the status of each sensor
in the network can be detected. All the CAN bus devices can be incorporated into the
NMEA2000 network. For detailed information about CAN bus wiring, see "FURUNO
CAN bus Network Design Guide" (Type: TIE-00170).
TZT16F
Connection examples for open-array sensors
DRS6A X-Class,
DRS12A X-Class, DRS25A X-Class
DRS6A-NXT, DRS12A-NXT,
DRS25A-NXT
To ship mains
(12* to 24 VDC)
HUB-101
*: 12 VDC is only used
with DRS6A-NXT. All
other open array DRS
sensors require 24
VDC.
2. WIRING
TZT16F
2-5
Advertisement
Table of Contents
