First Use - U-Line 1000 Series Quick Start Manual

Hide thumbs Also See for 1000 Series:

Table of Contents

QUICK START GUIDE

u-line.com

First Use

All U-Line controls are preset at the factory. Initial startup

requires no adjustments.

NOTICE

U-Line recommends allowing the unit to run

overnight before loading with product.

1200 SERIES

When plugged in, the unit will begin operating under the

factory default settings. If the unit was turned off during

installation, press and hold

for 5 seconds to turn unit

on.

1024BEV/1024R

MECHANICAL DIAL CONTROL

The control dial turns unit ON/OFF and sets temperature.

This set point temperature is a base setting used by the

controller to maintain the temperature zone in the unit.

The factory default MID setting, number 4 set point, is

approximately 38°F (3°C). The set point temperature is

a gauge for further temperature adjustments.

1024WC

MECHANICAL DIAL CONTROL

The control dial turns unit ON/OFF and sets temperature.

This set point temperature is a base setting used by the

controller to maintain the temperature zone in the unit.

The factory default MID setting, number 3 or 4 set point,

is approximately 50°F (10°C). The set point temperature

is a gauge for further temperature adjustments.

Publication Number 30628 11/2019 Rev.A

Table of Contents

1200 series 1024bev 1024r 1024wc