Maintenance - Dimplex Everdri Series Instruction Manual

Drainage
While the water tank is full, the compressor will stop for self-protection and the water
full indicator light will turn red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank carefully back into its location into
space. The tank must be properly located in order for the 'water full' light to go out
and for your dehumidifier to start operating again.
Please note, if the water tank has not been positioned/located correctly, the water full
indicator will stay red and the product will not operate.
CONTINUOUS DRAINAGE
When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent emptying. In this situation, it may be more convenient to set the
unit up for continuous drainage, this can be done as follows;
1. Pull out the water tank.
2. Connect a water drain tube of inner
diameter 11 mm to the drain spout
connection outlet at the top of the
tank location area.
* Please note, the water tube is not supplied
with the unit.
3. Ensure the drain tube is fixed properly
and that water will always drain away
freely through the tube (the drain
point/open end of the tube must be
at a lower height than the drain outlet
from the product).
Note! In very cold weather conditions,
precautions should be taken to prevent the
water tube from freezing.
4. Put the water tank back to its position.
12
Spout connection
for continuous
drainage
Water drain tube
with 11mm internal
diameter

Maintenance

Always unplug the unit from the mains before carrying out any maintenance or cleaning
of the unit.
CLEANING THE BODY
Use a soft damp cloth to wipe the unit clean.
Don't ever use volatile chemicals, gasoline, detergents, chemically treated clothes, or
other cleansing solutions. These all could possibly damage the enclosure.
CLEANING THE FILTER
This dehumidifier is equipped with 2 filters.
The plastic dust filter is washable and should be cleaned approximately every 2 weeks
when in use (see instruction below).
The active carbon filter is not washable its life span is variable and depends on the
ambient conditions where the unit is used. The filter should be checked periodically
and replaced if necessary.
Anti-Dust Active Carbon
Filter Filter
WASHING THE PLASTIC DUST FILTER
• Remove the anti-dust filter and separate the active carbon filter (not washable)
and set it aside carefully.
• Use a vacuum cleaner or tap the plastic air filter lightly for easy cleaning. If the
filter is particularly dirty, use warm water with a small amount of medium strength
detergent to rinse the filter.
• Allow it to dry naturally and make sure the filter is completely dry before replacing.
• Do not expose the filter to sunlight.
STORAGE
If not using the unit for an extended period of time. Please:
• Turn the unit off, unplug and take care of the mains lead & plug.
• Completely empty the water tank and clean it thoroughly and wipe it dry.
• Cover the unit and store it upright in a location where it will not receive direct sunlight.
NB- Prolonged exposure to direct sunlight will discolour the enclosure.
Air Inlet
13