Towing - Apogee Adapt-X Optimax User Manual

TOWING

Apogee Trailers uses a two-inch coupler (2", 5.08 cm)
Check that the size of the trailer ball of the towing vehicle is the same size as the
coupler. To attach your trailer follow the instructions below.
1. Open the clamping device on the coupler and attach the trailer to it.
2. Close the clamping device and insert a locking pin or padlock in the corre-
sponding pin hole.
3. Fit the safety chains in a criss-cross formation.
4. Connect the electrical wiring harness of the trailer to the electrical wiring of
the towing vehicle and check that the trailer lights work.
5. Check that the safety chains do not restrict the trailer from moving freely.
6. Check that the safety chains are not touching the ground.
CAUTION:
The trailer may detach from the towing vehicle if the towing vehicle's trailer
ball is not the same size as the coupler.
20