Unfolding The Trailer; Hitch Extender And Opening The Front Section - Apogee Adapt-X Optimax User Manual

CAUTION:
Be careful if you have to move the trailer when it is in the locked position
because it could tip over.

UNFOLDING THE TRAILER

To securely open your Optimax
carefully follow the instructions below.
OBSERVATION:
First you must attach the tongue, then open the front section followed by the
rear section. The unfolding operations must be performed on a flat surface.
1. TONGUE AND OPENING THE FRONT SECTION
To open the front section follow the instructions below. If necessary, consult
Figures 13 to 15.
Before opening the trailer, check to see if all the hitch pins are in position and if
the trailer is tipped onto the stops at the rear section. Fig. 13
1.1. Attach the tongue to the main body of the trailer by inserting it into its
corresponding section. Put the tongue pin in the corresponding pin holes.
Fig. 12 and Fig. 14
CAUTION:
If the tongue is not attached and you attempt to use the front section the
trailer could tip over toward the front.
1.2. Remove the tipping pin and the hitch pins from the front section.
1.3. Check that the tailgate pins are in position. Fig. 16
CAUTION:
If the tailgate pins are not in position, the tailgate may open when you attempt
to close the front section.
14
TM trailer and avoid any damages to it, please