Samsung NX58F5700WS User Manual page 71

Troubleshooting
PROBLEM POSSIBLE CAUSE
The control knob has been left
Surface burner
clicks during in the LITE position.
operation.
The burners Surface burner components
do not burn and caps are not assembled
evenly. correctly and level.
Surface burners are dirty.
Very large or Wrong orifice is assembled.
yellow surface
burner flames.
The oven door lock is turned
Surface
burners light on.
but oven
burners do not
light.
Gas Pressure Regulator
shut off switch is in the 'off
position.
SOLUTION
After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks,
contact a service technician.
See page 60.
Clean surface burner
components. (See pages 60
and 62.)
Contact your installer. Check
the burner orifice size and
contact your installer if you
have the wrong orifice. Check
the LP gas conversion.
The display will show the
Lock icon. Hold the oven door
open and press the START/
SET pad for 3 seconds. The
oven will beep and the Lock
icon will turn off.
Call a qualified service
technician.
PROBLEM POSSIBLE CAUSE
The electrical outlet Ground
Display goes
blank. Fault Interrupter (GFI or GFCI)
has been tripped and needs to
be reset.
Your digital control has been
damaged.
Very large or The oven burner air
yellow oven adjustment shutters need to
burner flames. be adjusted.
Gas supply is not properly
connected or turned on.
Food does not Wrong cooking mode is
bake or roast selected.
properly in the
The oven racks have not been
oven.
positioned properly for the
foods being cooked.
Incorrect cookware or
cookware of improper size
being used.
Oven thermostat needs
adjustment.
There is aluminum foil on
racks and/or oven bottom.
Clock or timers not set
correctly.
SOLUTION
Replace fuse or reset circuit
breaker.
Call for a qualified service
technician.
See the Installation
Instructions that came with
your range.
See pages 29-29, 39, 45.
See page 33, 45.
See page 26.
See page 37.
See page 33.
See pages 30 and 32.
English 71