Additional Cli Commands For A Usb Key - Fortinet FortiGate FortiGate-3016B Install Manual

FortiGate Firmware
1
2
3
4
5
6
1
2
3

Additional CLI Commands for a USB key

FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
01-30005-0343-20071113
Note: You need an unencrypted configuration file for this feature. Also the default files,
image.out and fgt_system.conf, must be in the root directory.
To configure the USB Auto-Install using the web-based manager
Go to System > Maintenance > Backup and Restore.
Select the blue arrow to expand the Advanced options.
Select the following:
• On system restart, automatically update FortiGate configuration file if default
file name is available on the USB disk.
• On system restart, automatically update FortiGate firmware image if default
image is available on the USB disk.
Enter the configuration and image file names or use the default configuration
filename (system.conf) and default image name (image.out).
The default configuration filename should show in the Default configuration file
name field.
Select Apply.
To configure the USB Auto-Install using the CLI
Log into the CLI.
Enter the following command:
config system auto-install
set default-config-file <filename>
set auto-intall-config {enable | disable}
set default-image-file <filename>
set auto-install-image {enable | disable}
end
Enter the following command to see the new firmware installation settings:
get system status
Use the following CLI commands when you want to delete a file from a USB key,
list what files are on the key, including formatting the key or renaming a file:
• exec usb-disk list
• exec usb-disk delete <filename>
• exec usb-disk format
• exec usb-disk rename <old_filename1> <old_filename2>
Note: If you are trying to delete a configuration file from the CLI command interface, and
the filename contains spaces, you will need quotations around the filename before you can
delete the file from the USB key.
Using a USB key
59