Factory Default Protection Profiles - Fortinet FortiGate FortiGate-100 Install Manual

Factory default protection profiles

30
Table 10: Factory default firewall configuration
Configuration setting Name
Firewall policy Internal -> External Source: All Destination: All
Firewall address All
Pre-defined service More than 50
predefined services
Recurring schedule Always
Protection Profiles Strict, Scan, Web,
Unfiltered
The factory default firewall configuration is the same in NAT/Route mode and
Transparent mode.
Use protection profiles to apply different protection settings for traffic controlled by
firewall policies. You can use protection profiles to:
• configure antivirus protection for HTTP, FTP, IMAP, POP3, and SMTP firewall
policies
• configure Web filtering for HTTP firewall policies
• configure Web category filtering for HTTP firewall policies
• configure spam filtering for IMAP, POP3, and SMTP firewall policies
• enable the Intrusion Protection System (IPS) for all services
• enable content logging for HTTP, FTP, IMAP, POP3, and SMTP firewall
policies
By using protection profiles, you can build protection configurations that can be
applied to different types of firewall policies. This allows you to customize types
and levels of protection for different firewall policies.
For example, while traffic between internal and external addresses might need
strict protection, traffic between trusted internal addresses might need moderate
protection. You can configure firewall policies for different traffic services to use
the same or different protection profiles.
You can add Protection profiles to NAT/Route mode and Transparent mode
firewall policies. The FortiGate unit includes four protection profiles.
Strict To apply maximum protection to HTTP, FTP, IMAP, POP3, and SMTP
traffic. You may not use the strict protection profile under normal
circumstances but it is available if you have problems with viruses and
require maximum screening.
Scan To apply antivirus scanning and file quarantining to HTTP, FTP, IMAP,
POP3, and SMTP content traffic.
Web To apply antivirus scanning and web content blocking to HTTP content
traffic. You can add this protection profile to firewall policies that control
HTTP traffic.
Unfiltered To apply no scanning, blocking or IPS. Use if you do not want to apply
content protection to content traffic. You can add this protection profile to
firewall policies for connections between highly trusted or highly secure
networks where content does not need to be protected.
FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
Description
Firewall address matches the source or
destination address of any packet.
Select from any of the 50 pre-defined
services to control traffic through the
FortiGate unit that uses that service.
The recurring schedule is valid at any
time.
Control how the FortiGate unit applies
virus scanning, web content filtering, spam
filtering, and IPS.
01-30004-0265-20070831
Factory defaults