Table of Contents
Advertisement
Gigaset E45 / USA EN / A31008-M1751-R101-2-6Z19 / start_guide_time.fm / 30.3.06
Appendix
Appendix
Care
¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
Your handset is splash and dust resistant.
If it comes into contact with water, knock
the water out of the microphone opening
and remove any water on the handset
with an absorbent cloth.
Your handset is ready for use.
If your handset comes into contact with a
larger amount of liquid take the following
steps:
1. Do not switch the handset on under
any circumstances!
2. Remove the battery pack immediately.
3. Remove the headset socket cover.
4. Hold the handset horizontally with the
open battery compartment facing
down.
5. Hold the handset vertically. Tilt the
handset backwards and forwards
slightly, giving it a gentle shake each
time.
6. Dab all parts dry and then leave the
handset for at least 72 hours with the
battery compartment open and the
keypad facing down in a dry, warm
place (not a microwave, oven or
similar).
When it has fully dried out, you will
normally be able to use it again.
20
Questions and answers
If you have any queries about the use of
your telephone, you can contact us at
any time at
www.siemens.com/gigasetcustomercare.
The table below contains a list of common
problems and possible solutions.
Troubleshooting
The display is blank.
!
1. The handset is not switched on.
2. The battery pack is empty.
The handset does not respond to a key press.
The keypad lock is activated.
¥
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
2. The handset has been de-registered.
Base Search is flashing in the display.
Handset is set for
is within range.
¥
Handset does not ring.
The ringtone is switched off.
¥
The other party cannot hear you.
You have pressed the
set is "muted".
¥
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
¥
Press and hold the end call key
¥
Charge/replace the battery pack
(page 5).
Press and hold the pound key
(page 9).
station.
¥
Reduce the distance between handset/
base station.
¥
Register the handset (page 6).
Best Base
and no base station
Reduce the distance between handset/base
station.
Activate the ringtone (page 18).
u
(INT) key. The hand-
Switch on the microphone again (page 9).
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.
a
.
#
Advertisement
Table of Contents
