Xconfiguration Cameras Camera [1] Focus Mode; Xconfiguration Cameras Camera [1] Gamma Mode; Xconfiguration Cameras Camera [1] Gamma Level; Xconfiguration Cameras Camera [1] Mirror - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Cameras Camera [1] Focus Mode

Define the camera focus mode.
Requires user role: ADMIN, USER
Default value: Auto
USAGE:
xConfiguration Cameras Camera n
where
n
: Unique ID that identifies the camera. Range: 1..1
Mode
: Auto/Manual
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set
the right focus; then auto focus is turned off to prevent continuous focus adjustments of
the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.

xConfiguration Cameras Camera [1] Gamma Mode

This setting enables gamma corrections, and applies only to cameras which support gamma
mode. Gamma describes the nonlinear relationship between image pixels and monitor
brightness.
Requires user role: ADMIN, USER
Default value: Auto
USAGE:
xConfiguration Cameras Camera n
where
n
: Unique ID that identifies the camera. Range: 1..1
Mode
: Auto/Manual
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref.
Cameras Camera [n] Gamma Level.
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API xConfiguration xConfiguration
Focus Mode: Mode
Gamma Mode: Mode
xCommand

xConfiguration Cameras Camera [1] Gamma Level

By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does
not provide satisfactory results. Requires the Cameras Camera [n] Gamma Mode to be set to
Manual.
Requires user role: ADMIN, USER
Default value: 0
USAGE:
xConfiguration Cameras Camera
where
n
: Unique ID that identifies the camera. Range: 1..1
Level
: Integer (0..7)
Define the gamma level.

xConfiguration Cameras Camera [1] Mirror

With Mirror mode (horizontal flip) you can mirror the image on screen. Mirroring applies both to
the self-view and the video that is transmitted to the far end
Requires user role: ADMIN, USER
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
n
: Unique ID that identifies the camera. Range: 1..1
Mirror
: Auto/Off/On
Auto: If the camera detects that it is mounted upside down, the image is automatically
mirrored. If the camera cannot auto-detect whether it is mounted upside down or not,
the image is not changed.
Off: Display the image as other people see you.
On: Display the image as you see yourself in a mirror.
44
API Reference Guide
xStatus Appendices
n Gamma Level: Level
n Mirror: Mirror
Copyright © 2016 Cisco Systems, Inc. All rights reserved.