Adjusting The Caster Position - Toro 30524 Operator's Manual

6. Remove the 2 axle adjustment bolts (Fig. 27).
1
E
D
C
B
A
Figure 27
1. Axle pivot bolt
7. Raise or lower the mounting bracket, so that you can
install the 2 axle adjustment bolts in the desired hole
location (Fig. 27). A tapered punch can be used to help
align the holes.
8. Tighten all 4 bolts.
9. Install drive wheels and lower the mower.

Adjusting the Caster Position

1. Using the Height-of-Cut Chart (on page 26), adjust the
caster spacers to match with the axle hole selected
(Fig. 28).
2
Figure 28
1. Clevis pin
2. Spacer, 3/16 in. (5 mm)
2. Remove the clevis pin, slide the caster from the support,
and change the spacers (Fig. 28).
3. Install the caster in the support and insert the clevis pin
(Fig. 28).
1
3
m–3791
3. Spacer, 1/2 in. (13 mm)
25