Table of Contents
Advertisement
Maintenance
4.
Pull the fuel line off fuel filter (Fig. 33).
5.
Open fuel shut-off valve for left and right tanks.
Allow gasoline to drain into a gas can or drain
pan. (Fig. 33).
Note:
Now is the best time to install a new
fuel filter because the fuel tank is
empty.
6.
Install the fuel line onto the fuel filter. Slide the
hose clamp close to the fuel filter to secure the
fuel line (Fig. 33).
3
4
2
Figure 33
1. Fuel shut-off valve
2. Fuel filter
46
1
3. Hose clamp
4. Fuel line
Greasing and Lubrication
Lubricate the machine when shown on the CHECK
SERVICE REFERENCE AID decal (Fig. 34). Grease
more frequently when operating conditions are
extremely dusty or sandy.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1.
Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
Remove the key.
2.
Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3.
Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
4.
Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the CHECK
SERVICE REFERENCE AID decal (Fig. 34).
Figure 34
Advertisement
Table of Contents
