Toro 07280 Operator's Manual page 34

Hide thumbs Also See for 07280:
Table of Contents

Advertisement

Problem
4 ashes
5 ashes
6 ashes
7 ashes
8 ashes
9 ashes
Off
Possible Cause
1. The line contactor is
not responding to
commands.
1. The charger interlock
switch is active.
1. Accelerator POT is out of
adjustment.
1. Battery voltage is out of
range.
1. The controller is
overheated.
1. The motor is over heated
or the battery is nearly
discharged (the vehicle
will go into the energy
saving mode).
1. The controller has failed.
34
Corrective Action
1. Turn the On/Off key to
the Off position, wait
a few seconds, and
turn the On/Off key to
the On position. If the
condition continues,
refer to your Authorized
Service Dealer.
1. Turn the On/Off key
to the Off position,
disconnect the charger,
and turn the On/Off key
to the On position.
1. Refer to your Authorized
Service Dealer.
1. Refer to your Authorized
Service Dealer to have
the batteries tested and
replaced if necessary.
1. The vehicle will continue
to run, but at reduced
power until the
controller cools down.
1. If the batter meter
displays more than one
bar, stop the vehicle
and allow the motor to
cool before operating
it again. If the battery
meter displays only one
bar, charge the vehicle
immediately.
1. Refer to your Authorized
Service Dealer.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman e2050

Table of Contents