Throttle Lever - Yamaha YFM35RX Owner's Manual

EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
CAUTION:
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18151
Light switch " /
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00040
CAUTION:
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
/OFF"
" to turn on the low beams
" to turn on
EBU18280

Throttle lever

Once the engine is running, movement of the throt-
tle lever will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the hand is removed from
the throttle lever.
1. Throttle lever
Before starting the engine, check the throttle to be
sure it is operating smoothly. Make sure it returns
to the idle position as soon as the lever is released.
EWB00250
WARNING
Malfunction of the throttle could make it diffi-
cult to speed up or slow down when you need
to. This could cause an accident. Check the op-
4-3
4