Adjusting The Anti-Scalp Rollers - Toro 74237CP Operator's Manual

Figure 17
1. Height of cut lever
2. To adjust, remove the clevis pin from the
height-of-cut bracket (Figure 17).
3. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired and,
insert the clevis pin (Figure 17).
4. Move the lever to the selected height.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
Adjusting the Outer Roller
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the flange
nut, bushing, spacer, and bolt (Figure 18).
2. Clevis Pin
1. Outer roller
2. Spacer
3. Bushing
4. Select a hole so that the outer roller is positioned
to the nearest corresponding height-of-cut desired
(Figure 18).
5. Install the outer roller, bushing, spacer, bolt, and
nut (Figure 18).
6. Torque the bolt to 40 to 45 ft-lb (54 to 61 N⋅m).
Adjusting the Center Rollers
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, remove the flange
nut, bushing, and bolt (Figure 19).
20
Figure 18
4. Bolt
5. Nut