Indication Panel; Nanoe Operation - Panasonic CS-XZ7SKEW Service Manual

14.11 Indication Panel

LED
Color
Light ON Operation ON
Light OFF Operation OFF Timer Setting OFF nanoe OFF ECONAVI OFF
Note:

If POWER LED is blinking, the possible operation of the unit are Hot Start, during Deice operation, operation
mode judgment, or ON timer sampling.

If Timer LED is blinking, there is an abnormality operation occurs.

14.12 nanoe Operation


This operation provides clean air by producing great amount of negative ions and distribute through the
discharge airflow to capture or deactivate molds, bacteria or viruses.

Generate nanoe (water wrapped ion particle) to moisturize skin.

nanoe operation start condition
During unit running at any operation mode, if nanoe operation is activated, combination operation (operation
o
mode + nanoe operation) starts.
During unit is OFF, if nanoe operation is activated, nanoe individual operation starts.
o

nanoe operation stop condition
When OFF/ON button is pressed to stop the operation.
o
When nanoe button is pressed.
o
When OFF Timer activates.
o

nanoe operation pause condition
When indoor fan stop (during deice, odor cut control, thermostat off, etc.). nanoe operation resume after
o
indoor fan restarts.
When indoor intake temperature ≥ 35°C and < 5°C. nanoe operation resume after indoor intake temperature
o
< 35°C or ≥ 5°C continuously for 6 minutes.

Indoor fan control
During any operation mode combines with nanoe operation, fan speed follows respective operation mode.
o
However, nanoe system enabled when fan speed ≥ 470 rpm to ensure proper negative ion distribution,
nanoe system disabled when fan speed < 470 rpm.
During nanoe individual operation, only Auto Fan Speed and no Powerful operation is allowed. Even if Fan
o
Speed button is pressed, no signal is sent to the unit and no change on remote control display. Auto Fan
Speed for nanoe individual operation is cooling medium fan.

Airflow direction control
During any operation mode combines with nanoe operation, airflow direction follows respective operation
o
mode.
During nanoe individual operation, only Auto Air Swing is allowed. Even if Air Swing button is pressed, no
o
signal is sent to the unit and no change on remote control display.

Timer control
When ON Timer activates when unit stops, previous operation resumes and restored last saved nanoe
o
operation status.
When ON Timer activates during any operation, no change on current operation.
o
When OFF Timer activates during any operation, all operation stops and the latest nanoe operation status is
o
saved.

Indicator
When nanoe starts, nanoe indicator ON.
o
POWER TIMER
White White
Timer Setting ON nanoe ON
nanoe ECONAVI
White White
ECONAVI ON
79