Replacing Mower Belt - Kubota ZD326-EU-2 Operator's Manual

72 PERIODIC SERVICE
(1) Spindle holder
(2) Blade
(3) 2-Cup washers
(4) Lock washer
(5) Bolt
(6) Spindle guard
A Tighten the 3 blade bolts to 98 to 117.6 N-m (10 to 12
kgf-m) of torque.
A The blade bolts have Right hand threads. Turn them
counterclockwise to loosen.
A To prolong the service life of the blades, reposition
them as shown in the figure below periodically.
(1) LH blade
(2) Center blade
(3) RH blade
BReplacing Mower Belt
To avoid serious injury or death:
A Be sure to reinstall the removed cover after
replacing the belt.
1. Remove the mower deck from the machine according
to the procedure "DISMOUNTING THE MOWER
DECK".
2. Loosen the nuts (B) to remove the center cover from
the mower deck.
(1) Center cover
(2) Left shield
(3) Right shield
(4) Grease up plate
3. Loosen the nuts (C) to remove the left and right hand
shield from the mower deck.
4. Clean around the gear box.
5. Remove the belt from the tension pulley.
6. Remove the right hand bracket which mounts the gear
box to the mower deck and slip the belt over the top of
the gear box.
7. To install a new belt, reverse the above procedure.
(A) Nut
(B) Nut
(C) Nut