Carrier 42NQV050M Service Manual page 85

No. Part name
n
Evaporator
(Heat exchanger)
o
Bearing
Procedures
4) Remove three fixing screw at the right
side of the heat exchanger, and separate
the heat exchanger from the back body.
(Figure 4, 5)
1) Follow to the procedure in the item
2) Remove the two screws used to secure the
bearing base.
3) Remove the bearing base.
<Caution at assembling>
• If the bearing is out from the housing, push it
into the specified position and then
incorporate it in the main body.
.
– 84 –
FILE NO. SVM-10052
One screw
(Figure 4)
One screw
(Figure 5)
Two screws
Two
screws
Bearing base
Bearing
Bearing base
Bearing