Carrier 42NQV050M Service Manual page 43

4. Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating
operation (except in DRY and FAN ONLY mode)
Press HI-POWER : Start and stop the operation.
5. ECO OPERATION
To automatically control room to save energy (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1 degree/
hour for 2 hours (maximum 2 degrees increase). For heating operation the
set temperature will decrease.
6. TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
without using the remote control.
• Operation mode is set on AUTOMATIC
operation, preset temperature is 24°C
and fan operation is automatic speed.
7. TIMER OPERATION
Setting the ON Timer
1
Press : Set the desired ON timer.
ON
2 Press : Set the timer .
3 3
Press : Cancel the timer .
Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting Daily Timer
1
Press : Set the ON timer.
ON
2
Press : Set the OFF timer.
OFF
· During the daily timer is activation, both arrows ( or ) are indicated.
Note:
· Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
· The setting will be saved for the next same operation.
8. PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by the
unit for future operation (except air flow direction).
1. Select your preferred operation.
2. Press and hold
displays.
3. Press PRESET : Operate the preset operation.
Press
Press
Press
3
Press
Press
4
mark flashing.
PRESET for 3 seconds to memorize the setting. The
– 42 –
Hi POWER FILTER PAP TIMER OPERATION
RESET
Setting the OFF Timer
: Set the desired OFF timer.
OFF
: Set the timer.
: Cancel the timer
SET
button during the ( or )
FILE NO. SVM-10052
mark
P