Setting The Cleaning Controls - Numatic TTB 4055/100 Owner's Instructions Manual

To activate the machine from SLEEP MODE press either trigger once.
Hi / Lo speed can only be toggled when the machine is in STAND-BY MODE.
Water ON / OFF can only be toggled when in ACTIVE MODE.
Brush / Vac Switch
STAND-BY
Stage 1.
Stage 2.
Stage 3.
ACTIVE
Stage 1.
Stage 2.
When the triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will
FRQWLQXH IRU  VHFRQGV WKLV LV WR FOHDU DQ\ ÀXLG UHVLGXH LQ WKH KRVH 
The panel if unused will automatically enter SLEEP MODE after 60 seconds.
If the brush motor keeps overloading consider using a different type of brush.
Or move the transit wheels to obtain different brush pressures,
Heavy brush load decreases the available battery run time.
Fig 27
can be cycled in both STAND-BY and ACTIVE MODE
Brush and Vac
Brush only
Vac only
Brush and Vac
Brush
Fig 28

Setting the cleaning controls

Brush overload.
7KH EUXVK /(' OLJKW ZLOO ÀDVK LI WKH EUXVK PRWRU KDV EHHQ
overloaded (Fig 28)
Releasing the handle triggers will allow the machine to stop
and reset.
34