Machine Setup; Fitting The Brushes; Tipping The Brush Deck - Numatic TTB 4055/100 Owner's Instructions Manual

!

Fitting the brushes

Featuring the Nulock brush system.
7KH EUXVK LV VLPSO\ SXVKHG DQG WZLVWHG WR ORFN PDNLQJ ¿WWLQJ DQG UHPRYDO D VLPSOH SURFHVV
The Pad is retained using Numatic's own PadLoc system. (Ask your supplier for details)
Only use manufacturer supplied brushes / pads.
TTB 4045 / ETB 4045 requires a 450mm brush or a 400mm pad.
TTB 4055 requires a 550mm brush or a 500mm pad
Safety gloves are recommended for the changing of used brushes.

Tipping the Brush Deck

ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
BEFORE MAKING ANY ADJUSTMENTS
Fit the brush /pad to the drive chuck,
twist to lock the brush
(Fig 14) / pad in place (Fig 15).
Fig 14
To tip the deck into the down position (Operating mode) Press in the brush
deck locking bar (Fig 16) and rotate the brush deck (Fig 17).
Fig 16
To change to brush deck up position, (Transit mode) simply lift the deck
and the sprung loaded locking bar will active to hold the deck up.
Fig 17
24
Machine Set-Up
Fig 15
!