Installing The Intrusion Switch; Removing The Power Switch - Dell OptiPlex 7040 - Mini Tower Owner's Manual

Installing the intrusion switch

1. Insert the intrusion switch into the slot on the computer.
2. Route the intrusion switch cable through the fan grommet.
3. Connect the intrusion switch cable to the connector on the system board.
4. Install the:
• bezel
• cover
5. Follow the procedure in

Removing the power switch

1. Follow the procedure in
2. Remove the:
• cover
• bezel
3. Open the front bezel
4. To remove the power switch:
a. Disconnect the power switch cable from the system board [1].
b. Unroute the power switch cable from the retention clip.
c. Press the release tab [2] and slide the power switch out of the computer [3].
After Working Inside Your
Before Working Inside Your
door.
Computer.
Computer.
21