Sony SRG-300H Technical Manual page 8

 SYSTEM SELECT switch
Used for setting the video format of the signal to be output
from the HDMI VIDEO connectors.
For details, see "Setting of the SYSTEM SELECT switch" (page
8).
 HDMI video connector
Supplies the images as a HDMI video signal or DVI video
signal.
 IR SELECT switch
Select the camera number when you operate multiple
cameras with the same infrared remote commander.
 VISCA IN connector
Connect to a computer via an RS-232 interface. When you
connect multiple cameras, connect it to the VISCA OUT
connector of the previous camera in the daisy chain
connection.
 VISCA OUT connector
When you connect multiple cameras, connect it to the
VISCA IN connector of the next camera in the daisy chain
connection.
 LAN connector (RJ-45 8-pin)
Connect to a switching HUB that is compatible with
10BASE-T/100BASE-TX using a LAN cable (category 5 or
higher, shielded twisted pair).
When a link is established, the green indicator lights, and it
flashes during communication. While connected with
100BASE-TX, the yellow indicator also lights.
Note
For safety, when connecting the peripheral device, do not
connect the connector that might have excessive voltage to this
connector. Follow the Operating Instructions for the
connection.
 12 V connector
Connect the supplied AC power adaptor.
 Reset switch
The reset switch is enabled only when the BOTTOM switch
is set to the LAN connection. When you press down this
switch with a pointed tip for about five seconds, the camera
will reboot and only the setting relating to the IP will return
to the factory setting.
Factory settings for IP
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Name: CAM1
Bottom
 BOTTOM switches
Used for LAN and VISCA CONTROL switching, RS-232
and RS-422 switching, 9,600 bps and 38,400 bps baud rate
selection and IR signal output setting.
For details, refer to the setting of the BOTTOM switches
(page 9).
 Tripod screw hole
 Fix-mounting screw holes
Setting of the SYSTEM SELECT switch
This switch allows you to select the video format of the
signal to be output from the HDMI video connector.
SRG-300H
Locations of Controls
Set this arrow to the
desired video format.