Sony SRG-300H Technical Manual page 15

When Auto Slow Shutter is Off (initial setting)
AGC
ICR
MAX
GAIN
ICR ON
Dark
ICR OFF  ON
When Auto Slow Shutter is On
Note
Depending on the information such as brightness, etc., in the ON/
OFF settings condition, a malfunction may occur when the subjects
largely consisting of blue and green colors are taken.
Shutter 1/60 sec
IRIS
OPEN
IRIS
SHUTTER
Bright
Camera ID
The ID can be set up to 65,536 (0000 to FFFF). As this
will be memorized in the nonvolatile memory inside,
data will be saved.
Picture Effect
It consists of the following functions.
• Neg. Art: Negative/Positive Reversal
• Black & White: Monochrome Image
Check for influence of installation
environment on infrared remote commander
operation
The supplied infrared remote commander may not
operate, only occasionally, in the vicinity of the inverter
lighting device. In this case, it is possible that the
camera is installed in a place where the infrared remote
commander cannot stably receive light due to the
emission of light from the lighting device.
In either the DC power or VISCA communication, it is
judged whether or not the infrared remote commander
is under the installation environment where it can
receive signal during the initialization process
performed after the power of camera is turned on.
The result of this judgment can be obtained using the
IR_ConditionInq command. (See page 41.)
If the installation environment is judged to be unstable
for operating the infrared remote commander, try to
take such measures as to install this unit in a place
away from the lighting device having the influence, and
so on.
Others
STANDBY
Sends the power off command. Or when the power is turned
off using the infrared remote commander, the camera
becomes STANDBY state. In the STANDBY state, the
camera can accept only the VISCA Commands and the
POWER ON of the infrared remote commander, and the
video signal output and other operations are stopped.
I/F Clear
Clears the Command buffer of the camera.
The buffer is cleared even during the power on state using
the control software.
Basic Functions
1