Options - Toshiba e-STUDIO 206L Quick Start Manual

Chapter 6 INFORMATION ABOUT EQUIPMENT

Options

The following options are sold separately, and upgrade the performance of the equipment if installed. For details,
contact your service technician or representative.
For e-STUDIO206L/256/306/356/456/506,
For e-STUDIO206L/256/306,
For e-STUDIO356/456/506,
1.
Original Cover (KA-1640PC)
This is used to hold an original.
2.
Reversing Automatic Document Feeder
(MR-3021, MR-3022)
This unit automatically feeds a stack of originals one by
one to have them copied. Install the MR-3021 in the
e-STUDIO206L/256/306, e-STUDIO256SE/306SE, and the
MR-3022 in the e-STUDIO356/456/506,
e-STUDIO356SE/456SE/506SE.
3.
Bridge Unit (KN-2520)
This unit acts as a relay for the Finisher and this equipment.
4.
Job Separator (MJ-5004/MJ-5006)
Enables Faxes, copies and prints to be output onto
separate paper trays.
Install the MJ-5004 in the e-STUDIO206L/256/306,
e-STUDIO256SE/306SE, and the MJ-5006 in the
e-STUDIO356/456/506, e-STUDIO356SE/456SE/506SE.
5.
Offset Tray (MJ-5005)
Enables copied and printed sets to be collated or stacked
in groups with each set being offset.
6.
Paper Feed Pedestal (KD-1025)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-1033).
7.
Large Capacity Feeder (KD-1026)
This feeder enables you to feed up to 2000 sheets (80 g/m
68
e-STUDIO256SE/306SE/356SE/456SE/506SE
e-STUDIO256SE/306SE
e-STUDIO356SE/456SE/506SE
9 10
11 13 12
14
15
6
or 20 lb. Bond) of A4 or LT paper.
8.
Additional Drawer Module (MY-1033)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-1025). Combined with the 2 drawers in the
equipment, paper can be fed from 4 drawers in total.
9.
Finisher (MJ-1101)
This Finisher enables sort/group finishing and stapling.
The Hole Punch Unit (optional, MJ-6103) can be installed
in this Finisher. The Bridge Unit (KN-2520) is required for
the installation of this Finisher.
10.
Saddle Stitch Finisher (MJ-1106)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(MJ-6103) can be installed in this Finisher. The Bridge Unit
(KN-2520) is required for the installation of this Finisher.
11.
Saddle Stitch Finisher (MJ-1033)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(MJ-6008) can be installed in this Finisher. The Bridge Unit
(KN-2520) is required for the installation of this Finisher.
e-STUDIO506/506SE does not support this option.
12.
Inner Finisher (MJ-1032)
This Finisher enables sort/group finishing and stapling
The Hole Punch Unit (MJ-6007) can be installed in this
Finisher.
e-STUDIO506/506SE does not support this option.
2
1 2
3
4
5
7 8