General Information; Troubleshooting; Accessories - Telefunken TF-DVBT206 Instruction Manual

Troubleshooting

Below is a table describing simple measures that can help you eliminate most problems likely
to emerge when this unit is in use. If below measures do not help, turn to a service center or to the
nearest dealer.
Trouble
The unit is not connected to the
Standby indicator
power supply mains.
is not on
The power cable is poorly connected.
The antenna is not connected.
The antenna is damaged/not
No signal
positioned.
Out of signal reception area.
Wrong signal source is selected on
No image
your TV.
The audio cable is poorly connected
or not connected
No sound The sound is muted or its volume set
to minimum.
The audio track is not supported.
The unit is switched off.
No responce from Wrong angle of RC usage or the front
the RC panel if the unit is shielded.
The batteries in RC are exhausted.
No DVBT signal
when setting up
the receiver
Delays in TV
playback Insufficient level of the received
signal at the antenna input.
Picture
interferences,
partial dropping
outs, picture
freezes, no sound

Accessories

1. Player
2. Remote controller
3. Battery
4. Audio video RCA cable

General information

Reason
5. Consumer information
1 pc
6. Warranty card
1 pc
7. Instruction manual
2 pcs
1 pc
Solution
Check the connection to mains.
Check the cable.
Check if the antenna cable is
connected.
Position the antenna.
Turn to the service provider.
Select the correct input signal
source.
Connect the audio cable properly.
Increase the sound volume.
Select another sound track.
Start the unit.
Use the RC at a correct angle or
uncover the front panel of the unit.
Change the batteries in the RC.
Check the connection and
integrity of the antenna amplifier
and its power lines.
1 pc
1 pc
1 pc
13
13