Table of Contents
Advertisement
Tools required:
Pliers
7/8" deep well socket with extension
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Traditional Whirlpool
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Remove the jet eyeball using the pliers. Pull
forward with a quick tug.
Step 2: Remove the adjusting cover. This should pull
out.
Tools required:
Philips head screwdriver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Traditional Whirlpool
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Unscrew Phillips head screw, located in the
center of suction cover, turning counter clockwise.
Step 3: For cleaning, refer to "Traditional Whirlpool
page 19.
Step 4: Put cover back on and replace Phillips head screw turning clockwise.
Document ID:06080001
Removal / Replacing Jet Parts
- Spa Cleaning and Disinfecting Procedures," page 19, for cleaning
(With Jets)
Step 5: Reverse steps to reassemble.
Removal / Replacing Suction Cover
- Spa Cleaning and Disinfecting Procedures," page 19, for cleaning
(With Jets)
Rev: B
Step 3: Remove the jet nozzle and nut using a 7/8"
deep-well socket and extension.
Step 4: For cleaning, refer to "Traditional Whirlpool
- Spa Cleaning and Disinfecting
(With
Jets)
Procedures" on page 19.
assembly.
The jet nozzle nut should be hand
tightened using the socket with extension. If the
adjustment cover is hard to turn, slightly loosen the
jet nozzle nut.
Step 2: Pull cover forward to remove.
- Spa Cleaning and Disinfecting Procedures" on
(With Jets)
Caution: Do not over tighten screw.
Technical Support: 800-626-6912
Clean this area, using low
foaming
soap
and
disinfectant, with a brush.
Remove
all
visible
residue and rinse with
clean water.
Reassemble the jet
Clean this area, using
low foaming soap and
disinfectant,
with
a
brush.
Remove all
visible
residue
and
rinse with clean water.
Page 20 of 24
Advertisement
Table of Contents
