Parts; Uction Cover - European Touch FORTE SPA Owner's Manual

Tools required:
Pliers
7/8" deep well socket with extension
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Traditional Whirlpool
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Remove the jet eyeball using the pliers. Pull
forward with a quick tug.
Step 2: Remove the adjusting cover. This should pull
out.
Tools required:
Philips head screwdriver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Traditional Whirlpool
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Unscrew Phillips head screw, located in the
center of suction cover, turning counter clockwise.
Step 3: For cleaning, refer to "Traditional Whirlpool
page 19.
Step 4: Put cover back on and replace Phillips head screw turning clockwise.
Document ID:06080001
R / R
EMOVAL
- Spa Cleaning and Disinfecting Procedures," page 19, for cleaning
(With Jets)
Step 5: Reverse steps to reassemble.
R / R
EMOVAL EPLACING
- Spa Cleaning and Disinfecting Procedures," page 19, for cleaning
(With Jets)
Rev: L
J P
EPLACING ET
Step 3: Remove the jet nozzle and nut using a 7/8"
deep-well socket and extension.
Step 4: For cleaning, refer to "Traditional Whirlpool
-
(With Jets)
Procedures" on page 19.
assembly. The jet nozzle nut should be hand
tightened using the socket with extension.
adjustment cover is hard to turn, slightly loosen the jet
nozzle nut.
S
UCTION
Step 2: Pull cover forward to remove.
- Spa Cleaning and Disinfecting Procedures" on
(With Jets)
Caution: Do not over tighten screw.
Technical Support: 800-626-6912
ARTS
Clean this area, using low
foaming soap
disinfectant, with a brush.
Remove all
residue and rinse with
clean water.
Spa Cleaning and
Reassemble the jet
C
OVER
Clean this area, using
low foaming soap and
disinfectant,
brush. Remove
visible residue
rinse with clean water.
and
visible
Disinfecting
If the
with a
all
and
Page 22 of 24