HP ProBook 470 G1 Maintenance And Service Manual page 87

9. If you need to remove the hinge covers from the display hinges, squeeze and pull the covers
straight up and off the display to remove them.
If you need to remove the hinge covers from the display hinges, pinch the top and bottom of the
hinges and then pull the hinges straight up and off the display.
Display hinge covers are available in the Display Hinge Kit using spare part number
723642-001.
10. If you need to remove the display bezel, remove the 2 mylar screw covers (1) and the 2 Phillips
PM2.5×4.0 screws (2) in the bottom corners of the display bezel.
11. Flex the top (3) of the bezel, the inside edges of the left and right sides (4), and then the bottom
(5) of the bezel until it disengages from the display enclosure.
NOTE: Make sure the hinges are not bent (see hinge position in following image) when you
remove the bezel.
Component replacement procedures 75