Table of Contents
Advertisement
13. Turn on the power (see page 16). Next, adjust
the incline to the lowest position (see step 4 on
page 17). Then, remove the key from the con-
sole, switch the reset/off circuit breaker to the
"off" position, and unplug the power cord.
Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
step 14 is completed.
Orient the Storage Latch (51) so that the large
barrel and the latch knob are in the positions
shown.
Remove the tie from the upper end of the
Storage Latch (51). Attach the upper end of the
Storage Latch to the Frame (55) with a 3/8" x
1 3/4" Patch Bolt (6).
14. Remove the tie from the lower end of the
Storage Latch (51). Keep the holes in the latch
cap aligned with the holes in the Storage Latch.
Make sure to keep the latch cap inside the
Storage Latch. Attach the Storage Latch to the
Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" Nut
(10). Note: It may be necessary to move the
Frame (55) back and forth to align the Storage
Latch with the Base.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 25).
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 27 and 28).
13
55
Latch
Knob
51
Large
Barrel
14
51
3
94
13
6
10
Latch
Cap
Advertisement
Table of Contents
