KTM 950 ADVENTURE 2004 Owner's Manual page 42

1
Remove the 3 screws , lift the tank approx. 15 mm and carefully tilt to
the side. Disconnect the connector from the pickup cable (fuel level) and set
1
the tank down.
1
1
2
Remove the lower screw on the right tank. Remove the HH screws and
3
take off the battery cover .
3
2
41
4
Remove the drain plug on the oil tank and allow the oil to drain into a
6
5 6
receptacle. Remove the screws and tilt the oil return valve to the side.
5
5
4
7
Carefully pull the oil screen out of the oil tank.
Thoroughly clean the drain plugs, the cover and both oil screens. Clean all
rubber seal rings and check for damage. Replace if necessary.
7
Mount the oil drain plug on the engine with a new seal ring and tighten to
20 Nm.
8
Slide the oil screen into the guides in the oil pump housing with the TOP
8
9
9
mark facing up. Make sure the form ring is in place and mount the cap .
Tighten the screws to 10 Nm.