KTM 950 ADVENTURE 2004 Owner's Manual page 37

Adjusting the headlight range
The payload can make it necessary to correct the headlight range.
1
The headlight range can be adjusted with the adjusting screw . Turning in
a clockwise direction will increase the headlight range, turning in a counter-
clockwise direction will reduce the headlight range.
TO CHECK:
Make a mark on a light wall behind a level surface at a height of 850 mm
(33.5 in) (950 Adventure S) or 810 mm (31.9 in) (950 Adventure) respec-
tively. Position your motorcycle loaded ready for the trip (baggage, driver,
1
passenger) 10 meters away from the wall and switch on the low beam. The
light/dark cut-off line should be at the mark.
Replacing the brake and tail light bulbs
2
Remove the hexagon nuts on the bottom of the fender and pull the tail
light off towards the rear.
2
2
36
BRAKE LIGHT BULB:
3
Turn the lamp socket approximately 30° counterclockwise and pull it out
of the tail light housing. Slightly depress the bulb, turn it approx. 30°
4
counterclockwise and pull it out of the socket.
3
To mount the lamp reverse the worksteps indicated above.
TAIL LIGHT BULBS:
4
4
Pull the socket out of the housing and pull the bulb out of the socket.
Replacing the flasher bulbs
5
Remove the screw on the back of the turn signal, carefully fold the lens
6
towards the motorcycle and remove. Turn the cap approx. 15° in a
counterclockwise direction and remove.
6
5
Slightly depress the bulb, turn it approx. 30° counterclockwise and pull it
out of the socket.
To mount the lamp reverse the worksteps indicated above.
6