Charging Battery - Panasonic JT-H340PR-E1 Operating Instructions Manual

Charging Battery

[By Battery Charger]
1) Put the Battery on the Charger slot and slide to
2) When charging, Charger LED blinks green. When charging is completed, Charger LED
constantly lights green. Charging function is limited to one Battery at any moment even if two
Batteries are set to the Charger.
When charging is completed in one slot, the charging of another slot starts automatically.
* Charging Time: approx. 2H per Battery
3) Remove the Battery from the Charger after Charging.
[By AC Adaptor]
1) Pull the DC Jack Cover.
Connect the plug of AC adaptor, to the DC jack of the printer.
2)
When the charge starts, the status LED lights red.
When the charge is completed, the status LED lights green.
3)
Remove the AC adaptor, and shut the connector cover.
DC Jack Cover
<Note>
The AC adaptor must use the special one (JT-H300AD-P1).
Don't open the battery cover, when charging.
AC adapter is for the exclusive use of battery charging.
The printer does not work when AC adapter is connected.
direction.
1)
Charger LED (Slot2) : Green
Power LED : Red
Charger LED (Slot1) : Green
2)
11