Emulate; Function Button - Panasonic PT-FW430E Operating Instructions Manual

PROJECTOR SETUP menu

EMULATE

When using the control commands for one of our
projectors that you have previously purchased to
control this projector using a computer via its serial
input terminal, set up the EMULATE function as
follows. This will allow you to use the control software
etc. designed for our existing projectors.
1 ) Press ▲▼ to select [EMULATE].
2 ) Press the <ENTER> button.
The [EMULATE] screen appears.
z
3 ) Press ▲▼ to select the required item.
4 ) Press the <ENTER> button.
Note
Refer to "Serial terminal" (
z
DEFAULT
D3500
D4000
D/W5k
D/W/Z6k
L730
L780
L735
L785
LB/W
58
- ENGLISH
Æ page 75).
FX400 Series, FW430 Series,
F100 Series, FW100 Series,
F200 Series, F300 Series,
FW300 Series
D3500 Series
D4000 Series
D5500 Series,
DW5000 Series, D5600 Series,
DW5100 Series, D5700 Series
D5000 Series, D6000 Series,
DW6300 Series,
DZ6700 Series,
DZ6710 Series,
DZ570 Series,
DW530 Series,
DX500 Series
L520 Series,
L720 Series, L730 Series
L750 Series, L780 Series
L735 Series
L785 Series
LB2 Series, LB1 Series,
LB75 Series, LB80 Series,
LB90 Series, ST10 Series

FUNCTION BUTTON

Three function buttons (<FUNC 1> to <FUNC 3>) on
the remote control can be assigned to any frequent
operations. They can be used as a useful shortcut
button.
To assign functions to the
J
<FUNC1> to <FUNC3> buttons
1 ) Press <MENU> button on the remote
control or the projector to select a
menu option (Main Menu, Sub-menu or
Advanced Menu).
For the on-screen menu selection, see
z
"Navigating through the menu". (
2 ) Hold down any of the <FUNC 1> to
<FUNC 3> buttons on the remote
control more than 3 seconds.
To cancel functions assigned
J
to the <FUNC1> to <FUNC3>
buttons
1 ) Press ▲▼ to select [FUNCTION].
2 ) Press the <ENTER> button.
3 ) Press ▲▼ to select [CANCEL] for
the function button (<FUNC1> to
<FUNC3>) assigned with the function.
4 ) Press the <ENTER> button.
5 ) When the confirmation screen appears,
press ◄► to select [OK], then press
the <ENTER> button.
Note
When the setting is complete, the following indicators
z
will apprear to the left of the assigned menu item (Main
menu, Sub-menu, or Advanced menu): F1 for <FUNC1>,
F2 for <FUNC2>, and F3 for <FUNC3>.
Æ page 33)