Panasonic WJ-ND300 Installation Manual page 7

• Indication label
Refer to the indication label placed on the surface of
the unit as to the indications of equipment classification
and power source, etc.
• Handle the unit with care.
Do not strike or shake, as this may damage the unit.
• Do not strike or give a strong shock to the unit.
It may cause damage or allow water to enter the unit.
• Place the unit horizontally on a level surface.
Do not place the unit in an upright position. When
stacking multiple units, clear a space of more than 5 cm
from both sides, the top, the bottom and the rear of the
units.
• Avoid placing receptacles that contain liquids such
as water near the unit.
If liquid spills onto the unit, it may cause fire or an elec-
tric shock.
• Prevent condensation from forming on the surface
of the hard disk.
If this happens, do not turn on the power of the recorder
and leave the recorder for around 2 hours.
Wait until the dew evaporates in any of the following
cases:
• The recorder is placed in an extremely humid
place.
• The recorder is placed in a room where a heater
has just been turned on.
• The recorder is moved from an air-conditioned
room to a humid and high-temperature room.
• When the unit has not been used for a certain period,
turn on the power of the unit (approximately once a
week), and perform recording/playback to prevent
interferences with functions.
• We recommend that you make a note of your settings
and save them. This will help when you are required to
change the system configuration, or when unexpected
trouble or failure occurs.
• Distributing, copying, disassembling, reverse compil-
ing, reverse engineering, and also exporting in violation
of export laws of the software provided with this prod-
uct, is expressly prohibited.
7