Connections; Connection Type - Panasonic WJ-ND300 Installation Manual

CONNECTIONS

The following are descriptions of how to connect the unit with PCs, cameras and an optional extension unit.
Required devices and cables vary depending on how to connect them. Before starting the connections, check the required
devices and cables for your environment.
The connection should be done in the following order:
PC → Cameras → Extension unit

Connection Type

Mode B
(Direct connection example: When using hubs)
Connect cameras and PCs using the CAMERA port and the client PC port on the rear of the unit respectively as shown in the
illustration below.
PC
Images (video signals) from cameras will be supplied (input) to the CAMERA port, and the supplied images will be transmitted
(output) to PCs.
Important: Do not connect PCs to a network to which the CAMERA port is connecting. Otherwise, transmission efficiency may
be down.
Do not connect any camera to a network to which the client PC port is connecting for the same reason.
PC
HUB
Network A
LAN Cable
(Not provided: 10BASE-T/100BASE-Tx, Category 5, Straight)
This Unit
10/100BASE-T
2 1
SERIAL
EXT STORAGE
PC CAMERA
Network Camera
ight
day/n
HUB
Network B
SIGNAL GND
POWER
AC IN
ALARM
ALARM/CONTROL
13