Hifonics Brutus BXi606 Manual page 6

BXi1206D / BXi1606D / BXi2006D MONO AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist: Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the - Connect the line inputs to a Radio/CD RCA outputs or line output of the
full range primary amplifier with good quality RCA cables. A "Y" adapter full range primary amplifier with good quality RCA cables. A "Y" adapter
may be needed as shown in the diagram. may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual - Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers speaker terminals, simplifying the hookup of multiple speakers
Crossover frequency control checklist: Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz - LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz - SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB - BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees - PHASE: 0 to 180 degrees
Level control checklist: Level control checklist:
- Refer to the section "Setting up systems after installation for best - Refer to the section "Setting up systems after installation for best
performance" performance"
DESIGNATED
*
MONO LINE INPUT
STEREO LINE
OUTPUT
B OOS T
H FR - 3
M I N M A X X
Dual Subwoofer Application
DESIGNATED
*
MONO LINE INPUT
STEREO LINE
OUTPUT
B OOS T
H FR - 3
M I N M A X X
4
Minimum final loudspeaker impedance: Minimum final loudspeaker impedance:
- 1 ohm. - 1 ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Note: You can use the Radio/CD designated mono line output
*
or a full range stereo line output. For full range stereo line output,
you will need an optional "Y-Adaptor" as shown
Y-ADAPTOR
MONO
SUBWOOFER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
PARALLEL MONO
SUBWOOFERS
2-OHMS EACH MINIMUM
MONO
SUBWOOFERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND