Table of Contents
Advertisement
I
nstallation
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
Upper
Connector
Fixing screw
Normal Tap without thread & one touch type inlet hose
1.
Untighten the upper connector
screw.
Upper
Connector
Fixing screw
• In case the diameter of the tap is
large remove the guide plate.
Guide plate
• Usable water tap for connecting
Hose.
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
2.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
Rubber
packing
Upper Connector
2.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
Rubber
packing
Middle
Upper Connector
connector
Middle connector
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
is inside the hose connector.
Connector
Hose
connector
Rubber packing
Rubber packing
Rubber
seal
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
Upper Connector
Plate
Water supply hose
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
Upper Connector
Water supply hose
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
Plate
9
Advertisement
Table of Contents
