Table of Contents
Advertisement
STEP 3: PREPARE THE VENTING BLOWER
To avoid risk of property damage, unplug the microwave oven or disconnect power at source by removing fuse
or throwing circuit breaker.
To avoid risk of personal injury, wear protective gloves when handling mounting plate.
Your microwave oven is shipped with the blower assembled for roof
venting. You need to adjust the blower if you want wall-venting or room-
vented (recirculating) installation.
DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling
and stretching the blower wiring could result in electrical shock.
Remove two screws that attach mounting plate to microwave oven cabinet.
See Figure 10.
Remove mounting plate and set aside. Replace the screws.
ROOF-VENTED INSTALLATION:
1.
Attach the exhaust adaptor to the blower plate by sliding it into the
guides. See Figure 11.
Go to STEP 4 on page 16.
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and two blower plate screws.
Remove the blower plate from cabinet.
See Figure 12.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts parts
Back plate. Discard knockouts.
Be careful not to distort the plate. See Figure 13.
4. Rotate the unit so that the exhaust ports face the rear of the cabinet. See
Figure 14. When you insert blower unit, blower wire must be like figure 14.
5. Place blower unit back into cabinet. Check that the exhaust ports face
towards the rear of the cabinet.
See Figure 15.
6. Reattach the blower plate to cabinet so the exhaust ports and blower
plate opening are aligned.
Attach with one blower unit mounting screw and then two blower plate
mounting screws.
See Figure 16.
INSTALLATION
back Plate
Parts "B"
Figure 13
CAUTION
CAUTION
Control panel side
ÒBÓ
from
blower unit
Knockouts Parts "B"
- 14 -
Figure 10
Mounting plate screws
Damper
Figure 11
blower plate
mounting screw
blower plate
Figure 12
Parts "B"
Figure 14
Mounting plate
Exhaust
adaptor
back plate
back plate
blower unit
mounting screw
blower
unit
exhaust
ports
Advertisement
Table of Contents
