Machine Operation; Pre-Run Machine Inspection; Starting Machine; Emergency Stop Procedures - Windsor QSC20 Operating Instructions Manual

PRE-RUN MACHINE INSPECTION

Do a pre-run inspection to find possible problems
that could cause poor performance or lost time
from breakdown. Follow the same procedure each
time to avoid missing steps.
NOTE: See maintenance section for pre-run
machine inspection checklist items.

STARTING MACHINE

NOTE: Perform pre-run machine check before
operating machine.
FOR SAFETY: Before starting machine, make
sure that all safety devices are in place and
operating properly.
1. Turn the machine power on.
2. Press the directional control button(s) to move
in the desired direction, if your machine is
traction model.

EMERGENCY STOP PROCEDURES

1. Release the directional control button(s), if
your machine is traction model.
2. Turn machine power off.
3. If an electrical problem is suspected push in
emergency stop button, if machine is
equipped with this option.
FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off
machine and remove key.
1. Turn the machine power off.
2. Remove solution tank cover.
3. Fill the solution tank with clean water, leaving
enough room for the required amount of
cleaning solution. The solution tank capacity
is 13 gallons (50 liters). The water must not
be hotter than 140° F (60°C) to prevent
damage to the tank.
4.
NOTE: Read the chemical manufacturers
recommended proportion instructions.
5.
!
Flammable materials can cause an explosion
or fire. Do not use flammable materials in the
tanks.
NORMAL SCRUBBING
Plan the scrubbing pattern in advance. The
longest track is around the perimeter of the area
to be cleaned. For efficient operation, the runs
should be the longest possible without turning,
stopping, or raising and lowering scrub
deck/squeegee.
NOTE: In order to achieve the best possible
results, the area which is to be cleaned should be
swept before scrubbing. Large debris, strings &
wire must be removed to prevent being caught in
the brush or squeegee.
SABER (QSC) 980067 11/13/02

MACHINE OPERATION

Measure the chemical into the solution tank.
Liquid chemicals should be added to the
solution tank after filling with water. Dry
chemicals should be thoroughly mixed before
being added into the solution tank.
Commercially available, high alkaline floor
cleaners, are suitable for use in the solution
system.
Replace solution tank cover.
WARNING
3-10