TANDBERG 770 MXP User Manual page 17

1. Microphone cable
 Connect the microphone to the microphone cable.
 Connect the microphone cable to microphone input 1 on the system.
2. Monitor cable(s)
Scart (Europe):
 Connect the Scart adapter to one of the Scart connectors on your monitor.
Scart (Europe) & RCA/S-Video (US):
Audio:
The cable with one RCA connector on one side and two RCA connectors on the other side:
 Connect the two RCA connectors to your monitor (or Scart adapter) Audio
Left/Right connectors (the audio signal from the system is a monaural signal and
therefore is fed into both audio-in sockets on the monitor).
 Connect the other end to 'Audio Out'.
Video:
 Connect the S-video cable to the S-video connector on your monitor ( or Scart
adapter). If you do not have an S-video connector on your monitor, connect the
RCA-RCA video cable to the RCA connector on your monitor.
 Connect the other end to 'Video Out'.
3. ISDN cables
 Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the
service provider. Your main number will be the number associated with the socket
to which ISDN cable number 1 is connected.
Note! Some systems and software versions do not support four ISDN lines.
North America: The system does not have a built-in network terminator. If your wall socket
provides you with an ISDN U-interface, you will need an NT1 between your system and
your ISDN line, see Appendix 1.
Note! Write down the numbers associated with each of the ISDN lines. You will need
them later to configure the system
Note! Connecting to the switched 56 network: When connecting to the switched 56
network you may use one of the BRI interfaces on the system. Please refer to Appendix
2 for further information.
4. Power cable
 Connect the power cable from the system's power connector to an electrical
distribution socket.
5a. LAN cable
 To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on
the system to your LAN.
5b. Wireless LAN - Insert PC Card
 Remove the "dummy" card by pressing the 'Eject' button next to the slot.
 Insert the Wireless LAN PC Card.
2 Installation
13