Table of Contents
Advertisement
Connecting the Computer and Copier
7
Enter the IP address for the copier into the
Address
8
Select Custom, and then click [Settings].
9
Select
10
Enter "9100" for the
11
Click [Next>].
12
Click [Finish].
7.2.4
IPP Printing
Windows 2000/ Windows XP
Important
Before continuing to set up the network settings, check the following:
Check that the computer is set up to use the TCP/IP protocol.
Check that the copier is also set up to use the TCP/IP protocol.
Check the IPP Settings Using PageScope Light/Network
Management Utility Light
Use PageScope Light/Network Management Utility Light to access the
copier and check if IPP printing is enabled. For instructions on using
PageScope Light/Network Management Utility Light, refer to "8 Using
PageScope Light/Network Management Utility Light".
1
Start up PageScope Light/Network Management Utility Light.
2
Log in to the Administrator mode.
3
Click the "Network" tab, and then select "IPP Configuration" in the
menu.
4
Check that
not possible.
KN-419
box, and then click [Next>].
RAW
as the protocol.
Port Number
Enable IPP
is selected. If it is not selected, IPP printing is
Printer Name or IP
setting, and then click [OK].
7
7-7
Advertisement
Table of Contents
