Installing Air Conditioner Into Wall Sleeve - Fedders A6U10W2A Operating Instructions Manual

Installing the air conditioner into the wall sleeve
1. Replace any damaged foam inside the wall sleeve with
TABLE OF CONTENTS
replacement foam. Two pieces of adhesive backed
replacement foam are provided, one vertical piece (15 3/4" x
3/4" x 1") and one horizontal (25" x 3/4" x 1").
INSTALLATION
2. Depending on the model, your air conditioner may weigh as
ELECTRICAL REQUIREMENTS
much as 95 pounds. To insure safe handling, obtain the
& SAFETY PRECAUTIONS
necessary help to lift and position the unit during installation
and removal.
3. Slide air conditioner fully into the sleeve. (Fig. 9) The air
conditioner should be centered in the sleeve so that all seals
bear evenly to prevent air leakage. NOTE: THE UNIT IS
APROX. 6" DEEPER THAN THE SLEEVE. THE UNIT WILL
PROTRUDE APROX. 6" FROM THE SLEEVE INTO THE ROOM.
When installation is complete, the unit must have a
rearward slope to prevent condensate water from
entering the room. (Fig. 10) Check with a level.
TROUBLESHOOTING
WARRANTY
INSTALLATION
Installing the trim frame
The trim frame covers any gaps between the wall sleeve and the
air conditioner.
INSTALLATION
1. Assemble trim frame by laying the 4 frame pieces face down
on a flat surface and snapping them securely together.
(Fig. 11)
2. Install the 20" x 1/2" x 1/8" adhesive backed insulating foam
INSTALLATION
around the inside edge of the trim frame. Begin in the
bottom left corner and place the insulating foam around the
entire inside of trim frame.
3. Slide the trim frame onto the air conditioner until the foam
makes a seal with the wall sleeve. (Fig. 12)
OPERATION
ELECTRONIC CONTROLS
MAINTENANCE
9
Wall sleeve
10
Air conditioner
(inside of room)
Rearward
slope
11
Trim frame
12
Wall sleeve
8
INSTALLATION
INSTALLATION
OPERATION
TROUBLESHOOTING
Air conditioner
INSTALLATION
ELECTRICAL REQUIREMENTS
& SAFETY PRECAUTIONS
Wall
sleeve
(outdoors)
Trim frame foam
(2 pieces)
20" x 1/2" x 1/8"
Trim frame
MAINTENANCE
E
N
G
L
I
S
H