Operation; Electronic Controls - Fedders A6U10W2A Operating Instructions Manual

TABLE OF CONTENTS
Section A
INSTALLATION
Dimensions of wall sleeve
ELECTRICAL REQUIREMENTS
Width Depth Height
& SAFETY PRECAUTIONS
26 3/4" 15" 15 3/4"
26 3/4" 15" 15 3/4"
26 3/4" 15" 15 3/4"
25 1/2" 19" 15 5/8"
25 1/2" 22 9/16" 15 5/8"
25 1/2" 22 9/16" 15 5/8"
25 1/2" 19" 15 5/8"
Warning:
This type of sleeve will require you to remove the existing
rear grille and install the new grille that came with your
unit. If this new rear grille is not installed in the wall sleeve
TROUBLESHOOTING
your unit will not operate correctly and the warranty will be
void.
1. Remove screws attaching the existing grille to the wall sleeve.
2. Remove the existing grille.
WARRANTY
3. Clean out any debris.
4. Insert new grille into sleeve. (Fig. 4)
Note: Make sure that the word "Top" can be read from inside
the room.(Fig. 5) INSTALLATION
5. Secure the grille to the back of the sleeve with the six (6)
screws (provided). The screws will attach through the holes in
the grille and into the corresponding holes in the sleeve.
INSTALLATION
(Fig. 5)
INSTALLATION

OPERATION

ELECTRONIC CONTROLS

MAINTENANCE
Wall Sleeve
Manufacturer
Emerson Quiet Kool
Fedders
Maytag
Sears
Sears
Whirlpool
Whirlpool
6
INSTALLATION
4
Wall sleeve
OPERATION
TROUBLESHOOTING
INSTALLATION
ELECTRICAL REQUIREMENTS
& SAFETY PRECAUTIONS
5
View from inside of room
# 8-32 self tapping
Phillips head screws
(6 pieces)
Note: Make sure that the word
"Top", stamped into the rear
grille, can be read from inside
the room.
MAINTENANCE
Rear grille
E
N
G
L
I
S
H