Installing The Rear Grille Into An Existing Wall Sleeve - Fedders A6U10W2A Operating Instructions Manual

Installing the rear grille into an
existing wall sleeve:
1. Measure the dimensions of your existing wall sleeve. (Fig. 3)
2. Locate your wall sleeve in the wall sleeve identification chart
below.
If you have any questions or if your sleeve is not listed please
call 217-347-6459 or email customerservice@fedders.com.
You must install the new grille included with your air
conditioner. Failure to do so could damage the unit
and will void the warranty.
Wall sleeve identification chart
Determine the type of wall sleeve you have from the chart below
and follow the instructions and warnings in the section indicated.
Dimensions of wall sleeve
Width Depth Height
25 7/8" 18" 15 9/16"
25 3/4" 18 5/8" 16 7/8"
26 3/4" 15" 15 3/4"
26 3/4" 15" 15 3/4"
27" 16 3/4" 16 3/4"
27" 19 3/4" 16 3/4"
27" 16 3/4" 16 3/4"
25 7/8" 16"/18"/22" 15 7/8"
26" 16 7/8" 15 5/8"
25 7/8" 16 23/32" 15 17/32"
26 3/4" 15" 15 3/4"
25 1/2" 19" 15 5/8"
25 1/2" 22 9/16" 15 5/8"
27 3/8" 15 3/4"
25 1/2" 22 9/16" 15 5/8"
25 1/2" 19" 15 5/8"
25 1/2" 22" 15 1/4"
Wall Sleeve
Manufacturer
Carrier (52F series)
Carrier (51S Series)
Emerson Quiet Kool
Fedders
Fedders "A" chassis (BSA000D)
Fedders "B" chassis (BSB000D)
Friedrich
Frigidaire
General Electric/Hotpoint
LG
Maytag
Sears
Sears
16" Welbilt
Whirlpool
Whirlpool
White-Westinghouse
If your existing sleeve is 27"wide or greater, STOP HERE.
These sleeves require a larger rear grille than the one provided with this unit and different
installation parts. You will need to order kit number A38500W from your local distributor.
Included in the kit is a rear grille, larger trim frame, rear air deflector, baffles, and larger foam
pieces that will be needed to correctly install your air conditioner in a wall sleeve that is 27
inches wide or greater than 27 inches. Please contact the distributor where you purchased the
unit. If you do not install your new air conditioner using this kit you will cause damage to the
air conditioner and the warranty will be void.
3
Height
Width
Follow instructions
under section
Section B
Section B
Section A
Section A
See note below
See note below
See note below
Section B
Section C
Section B
Section A
Section A
Section A
See note below
See note below
Section A
Section B
5
Wall Sleeve
Depth