Advertisement
Y
V
lift!
our
iVa
3
4
5
Identification Key
1. Control box
®
P
r
ower
eCliner
A-A
B-B
A
1
1. If your model has back wings, align the KD
sleeves, and slide the wing down into place.
Please note there is a label on the brackets.
Please assemble them as indicated (A-A and
B-B).
2. Connect the power transformer cable to the
corresponding plug coming from the back of
the chair.
3. Connect the power cord into the power
transformer.
4. Connect the power cord into an electrical outlet
near where the chair will be used.
With the chair upside down, locate the
junction box in the back corner. Carefully
pull the cables, taking up slack, and
plug in the three small cables first.
Ensure all of the cables are run along
the chair base frame and not through
the mechanism, and secure wires in
clips along the inside chair frame.
B
For chairs equipped
with a control box, plug
the cable marked "A"
into the control box's
"A" port, and the cable
marked "B" into the
control box's "B" port.
Plug
the
controller
cable into the center
wire connector.
5
Advertisement
